A rectangular squeeze film bearing will be used to absorb intermittent loads. The bearing is 500mm wide. The initial gap between the bearing plates is 2mm. The applied load is 50N. Oil viscosity 1000 mPa-s.
a) If the bearing gap should change to 1mm in 0.5s, how long will you make the bearing?
b) Using your calculated length, how long will it take to move if the viscosity is changed to 300 mPa-s?
1
Expert's answer
2019-11-18T08:25:51-0500
Dear Noah, your question requires a lot of work, which neither of our experts is ready to perform for free. We advise you to convert it to a fully qualified order and we will try to help you. Please click the link below to proceed: Submit order
Numbers and figures are an essential part of our world, necessary for almost everything we do every day. As important…
APPROVED BY CLIENTS
From my initial experience to now, I have to admit the service level has increased exponentially. I had my doubts at first and then there were misses, however, overtime they have been doing what they could to improve my experience.
Comments
Leave a comment