Answer to Question #18246 in MatLAB | Mathematica | MathCAD | Maple for md dzly
A unity feedback control for a vehicle manoeuvring system is given in the following diagram:
where K = 100 and G(s) =1/(s.s)(s+4)(s+8)
The initial design of the system is not very good with regards to the step input. As an engineer, you have been given the task to improve certain performance criteria of the system. To complete your assignment, you are to analyse the system design and give some recommendations for improvement. You are required to submit a complete report detailing your work.Improve the system as follows. Find out what cause the problems. Suggest the actions you may try to solve the problem. Try out your solution using Matlab. Once you have obtained an acceptable design, reproduce the step response, bode plot and root locus. Make sure that all three plots agree with each other in term of performance criteria. Your new performance criteria must be clearly printed on the plots. Compare your new design with the initial one. (Note: you are improving the system, not changing it .
Unfortunately, your question requires a lot of work and cannot be done for free. Submit it with all requirements as an assignment to our control panel and we'll assist you.
Dread it, run from it, the end of summer arrives all the same. And now it's here. It’s finally August.…
APPROVED BY CLIENTS
I was very happy with the results after after a misunderstanding of the instructions of the paper. i would've liked to get some graphs or charts showing me the results from Stats, but since I didn't ask for, it's fine.